Ol' fart
Well-Known Member
- Messages
- 1,238
- Location
- Saratoga CA
I had some tubing laying around from boat railing so made these to stop the cups from cracking. The inside is a perfect press fit so all I do is part them off, deburr and press them on. It fits on all the drive cups on the car. If there is interest I could have stock parts for sale with this mod done. I can't sell just the rings because you'll need a special press to get them on that's too expensive. They are so cheap to make and install that the stock price would cover the cost of the sleeves and installing them so it's a no brainer. Better than stock, same price as stock.
Oh, one thing. They will not fit in a stock front bearing holder, no room.
Oh, one thing. They will not fit in a stock front bearing holder, no room.
Last edited by a moderator: