phreerider
Senior Member
- Messages
- 1,111
heres a shot of mine , basic brass hardware nipple and hose (that you already have ) and on the other end a fuel filter its the screen type
leave the rubber dome and seal inside the cap for splash cover just be sure its open.
you can use solvent tolerant sealer around the nipple but i did not .
drill slightly smaller hole than nipple choice. has to be self tapping tight fit into plastic, don't over tighten. the tubing and filter should be secured to form a loop down toward bottom of tank somewhere, it will spit out a little fuel from time to time. leave enough slack to allow for cap placement and removal, the twist thing you can figure out . when in place ,the tubing should not pinch itself closed after tighten cap...and looks like
leave the rubber dome and seal inside the cap for splash cover just be sure its open.
you can use solvent tolerant sealer around the nipple but i did not .
drill slightly smaller hole than nipple choice. has to be self tapping tight fit into plastic, don't over tighten. the tubing and filter should be secured to form a loop down toward bottom of tank somewhere, it will spit out a little fuel from time to time. leave enough slack to allow for cap placement and removal, the twist thing you can figure out . when in place ,the tubing should not pinch itself closed after tighten cap...and looks like