Dreggsta
Senior Member
- Messages
- 818
- Location
- Baton Rouge, LA
rcdad you asked where the pics were. it's not done yet but it's very close to being done & then i can start on mine which will be an xt w/the body lowered as far down til it touches the spark plug cage. it'll have the xb rear wing on it too. it'll get cut some but not sure yet in how bc my focus is on getting my son's xt-b done.
my son's & mine have: copper drive cup braces (6 total per vehicle), 1" velocity stacks, dt1 dual folw filter, tgn pre-airfilter, ddm pull start prefilter, alum gear plate, alum front chassis brace, alum front/rear shock towers, killer bee, voltwatch2, 7075rc front/rear hubs, xb rear wing, xq throttle/steering servos, ngk spark plug & fuel vent.
my son's & mine have: copper drive cup braces (6 total per vehicle), 1" velocity stacks, dt1 dual folw filter, tgn pre-airfilter, ddm pull start prefilter, alum gear plate, alum front chassis brace, alum front/rear shock towers, killer bee, voltwatch2, 7075rc front/rear hubs, xb rear wing, xq throttle/steering servos, ngk spark plug & fuel vent.
Last edited by a moderator: