Hey guys, last week i overheated the clutch on my xb, wich in turn caused my gearplate to break around the bearing on the b/c shaft, i got an aluminum mt/dr plate and bearings from rcdad, got those installed without a hitch, went out this evening and ran the car and everything feels tight and smooth but at idle there is a slight metallic almost screeching sound and as the revs increase so does the sound for the first two feet then the nooise goes away and is fine, its not doing anything weird other than this noise, any ideas what this could be? did i smoke my clutch? it runs and drives great otherwise, no slipping or anything, or is the aluminum plate somehow amplifying noise that the plastic xb plate hides, i'm just trying to make sure im not getting ready to screw something else up...