DemonRC
Senior Member
- Messages
- 1,846
- Location
- Houston, TX
Ok so two runs in a row I had major front end trama which resulted in two busted diff housings. First, was a 10ft nosedive off a hill and I landed on my front right wheel. Today, at the beach, I nailed a garbage container at full speed. My same right front wheel caught it. The impact pushed the front diffs rear hinge pin plate backward, bends it, and snaps the diff housing. Notice that both breakages are at the right rear chassis bolt location. Does the RAMTech Front End Suspension Arm Holder fit on the rear side of the front diff housing? Can anybody confirm this? If so, it should help the problem since it has two bolts to keep it from moving. Right now the stock setup puts all the stress on the diff housing.
OH... GOOD NEWS! That same suspension arm survived both impacts. I boiled mine before I ever started my TT up.
P.S. Ever see a Baja rocket up a 15ft wall? I'm talking 90 degrees f#$%#$ straight up. I've got video to prove it and will get it up as soon as my buddy get's it off his camera. It's insane. You guys are gonna think it's doctored. We did it a few times just to show that it wasn't a freak accident.
OH... GOOD NEWS! That same suspension arm survived both impacts. I boiled mine before I ever started my TT up.
P.S. Ever see a Baja rocket up a 15ft wall? I'm talking 90 degrees f#$%#$ straight up. I've got video to prove it and will get it up as soon as my buddy get's it off his camera. It's insane. You guys are gonna think it's doctored. We did it a few times just to show that it wasn't a freak accident.
Last edited by a moderator: