QIK-RX4
Junior Member
- Messages
- 11
- Location
- Townsville, Australia
Here is my better half's buggy.
As you can see by the pics its had a few mod's done.
Alloy gear carrier.
Alloy rear hubs.
Alloy front hubs and alloy outers.
Alloy front and back suspention arm holders.
HPI air filter.
GP290 engine.
8000rpm clutch spring.
Reversed the clutch shoes.
Outerwears covers.
14kg didgital throttle servo.
Spektrum DX3.0
HPI H/D and STD front coil springs fitted both ends.
Mugen 5000wt diff oil front and rear centres.
Ramtech diff centre pins upgraded.
All bearings replaced with rubber sealed ones.
Custom header pipe with a carson tune pipe.
4600mh batt pack.
MCD steel gears.
MCD plastic gears.
Next mods are HPI SS rear wheel exenders and a set of HPI wheels and tyres. I cant see these std ones lasting to long.
Would like to thank Mike at PowerSlideRacing and Rob from Rampage Hopups for there help.
Cheers,
Rob.
As you can see by the pics its had a few mod's done.
Alloy gear carrier.
Alloy rear hubs.
Alloy front hubs and alloy outers.
Alloy front and back suspention arm holders.
HPI air filter.
GP290 engine.
8000rpm clutch spring.
Reversed the clutch shoes.
Outerwears covers.
14kg didgital throttle servo.
Spektrum DX3.0
HPI H/D and STD front coil springs fitted both ends.
Mugen 5000wt diff oil front and rear centres.
Ramtech diff centre pins upgraded.
All bearings replaced with rubber sealed ones.
Custom header pipe with a carson tune pipe.
4600mh batt pack.
MCD steel gears.
MCD plastic gears.
Next mods are HPI SS rear wheel exenders and a set of HPI wheels and tyres. I cant see these std ones lasting to long.
Would like to thank Mike at PowerSlideRacing and Rob from Rampage Hopups for there help.
Cheers,
Rob.