Dobber72
Well-Known Member
- Messages
- 80
- Location
- Booneville
I recently was checking bolts and nuts for tightness on my rampage xt drive gears,I had lost a set screw in one of the square spacer pieces between the drive gears.so I put a new set screw in and took everything apart and there was a washer on the clutch gear side that was in between the spacer and the gear and not between the bearing and spacer like the manual shows so I put it back together like the manual shows and it ran it for a few minutes and it is getting bad hot around the clutch and smeels like burning plastic so I don't know what's going on now unless the washer should go back to where it was or I over tightened the nuts holding the gears on because I don't really know how tight those should be they were pretty loose from the factory.so any help would be appreciated.Thanks