ipsagel
Member
- Messages
- 69
- Location
- Phonix, Az
Hello guys!
Anybody has an idea what went wrong with my Rampage why my steering servo keeps on burning? The first servo that burned was the stock one when I was running about half tank of fuel during my first ran of the truck out from the box. I replaced it with Hitec HS-5745MG, and using the Aggressor radio. Today I'm suppose to run my rig for the 3rd time since I put the 5745 servo. While preparing it to go, I always check the throttle fail safe if it's still working, turned the transmiter off and on. Just notice a bad smell and a smoke coming out from the servo. My steering linkage is not tight, but I notice every time I turned the transmiter off the servos went crazy and tend to glitch. I owned a few nitro RC's but I didn't notice this servo behavior when I turned my transmiter off.
Anybody has an idea what went wrong with my Rampage why my steering servo keeps on burning? The first servo that burned was the stock one when I was running about half tank of fuel during my first ran of the truck out from the box. I replaced it with Hitec HS-5745MG, and using the Aggressor radio. Today I'm suppose to run my rig for the 3rd time since I put the 5745 servo. While preparing it to go, I always check the throttle fail safe if it's still working, turned the transmiter off and on. Just notice a bad smell and a smoke coming out from the servo. My steering linkage is not tight, but I notice every time I turned the transmiter off the servos went crazy and tend to glitch. I owned a few nitro RC's but I didn't notice this servo behavior when I turned my transmiter off.