Search results

Tj

Sweet could you post a pic of them when installed on your rampage thanks

I have a losi 5 and no the diff cup will not fit because it's bigger in diameter where the pin goes thru and doesn't mesh with any other gears from the rampage diffs

My breaks work perfect in my chimera what I did was replace the two set screws with two screws that were a little bit longer and loctited them it removed the slop in the pads and I used fuel line on the linkage instead of the spring stops on a dime

Nice are the shocks wider in diameter than the stock ones. I'm actually in the process of fitting losi 5b shocks to my chimera so just wondering cause the rampage vehicles shocks are a bit undersized

The screws that hold your carb in are probably loose. Remove the screws inspect carb intake gasket is not worn then apply blue locktite and tighten those carb screws back on and let the locktite dry for 24hrs that'll stop the air leaks

Nice cat, I'm likin those tires looks sick

I just sent you a pm of my number you can contact me

Thanks I forgot to mention that to you and i wanted to make an order for some rear a arms and shock tower for my chimera

Thanks Phil it's been fun upgrading this buggy it's really starting to rip now

Hey Doug I never received the stainless sleeve for the servo saver with my order and my spring has a bend in it. Your right it's been hard to set it up straight.

Ive been running the buggy in sand a lot so I bought the hpi Baja air filter setup. This improved the engine by helping it breathe better very highly recommend it. Don't mind the tape on the throttle linkage I was in a hurry and it worked and had to modify the linkage to work.

Here's how she sits at the moment

I also had to dremel out part off the roll cage front section that connects to the chassis in order for it to fit properly.

once I was able to fit the bumper between the chassis and the diff case the srews are left protruding out like this. But I was told if I use a tbone aftermarket bumper that it will be a more proper fit. To bad because I kind of like the stock bumper I haven't broke it yet.

theres a few things that weren't fitting properly on the 7075rc chassis. Like the front bumper which I had to shave off a bunch of material to fit.

I had it all built back up with the stock motor in it only to have the engine finally give out the black smoke on the first run with the new chassis. So I went home and ordered a Zenoah g320rc engine, hpi Baja air filter complete set and a snappy rc fuel line kit.